Device under test

Device under test (DUT), also known as equipment under test (EUT) and unit under test (UUT), is a term used to refer to a manufactured product undergoing testing, either at first manufacture or later during its life cycle as part of ongoing functional testing and calibration checks. This can include a test after repair to establish that it's performing in accordance with the original product specification.

Electronics testing

The term DUT is used within the electronics industry to refer to any electronic assembly under test.[1][2] For example, cell phones coming off of an assembly line may be given a final test in the same way as the individual chips were earlier tested. Each cell phone under test is, briefly, the DUT.

For circuit boards, the DUT is often connected to the test equipment using a bed of nails tester of pogo pins.

Semiconductor testing

In semiconductor testing, the device under test is a die on a wafer or the resulting packaged part. A connection system is used, connecting the part to automatic or manual test equipment. The test equipment then applies power to the part, supplies stimulus signals, then measures and evaluates the resulting outputs from the device. In this way, the tester determines whether the particular device under test meets the device specifications.

While packaged as a wafer, automatic test equipment (ATE) can connect to the individual units using a set of microscopic needles. Once the chips are sawn apart and packaged, test equipment can connect to the chips using ZIF sockets (sometimes called contactors).

See also

References


This article is issued from Wikipedia - version of the 9/3/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.