Great Bear (roller coaster)

Great Bear is an inverted roller coaster located at Hersheypark in Hershey, Pennsylvania. Designed by Werner Stengel, the roller coaster was built by Bolliger & Mabillard (B&M) and opened in 1998 in the Kissing Tower Hill section of the park. Due to surrounding terrain and proximity to other attractions, the coaster was one of B&M's most difficult installations. The supports weren't permitted to be built in nearby Spring Creek, and the limitation resulted in an unusual support structure design for a B&M coaster.

Ride experience

Riders exit the station and climb a 90-foot (27 m) hill. Unique to Great Bear, there is a helix immediately after the lift, swinging riders around into the 124-foot (38 m) drop into The Hollow. After the drop, train enters a loop, followed immediately by an Immelmann loop, and then going into a zero-g roll. Riders continue through The Hollow over midway areas, making a sharp turn over Spring Creek. After a short straightaway, the train goes into a corkscrew, and then up a hill with two wide turns. For the 2014 season, the on-ride camera's location was changed to just after the corkscrew inversion, on the same pole that houses the on-ride camera for SooperDooperLooper. The train then enters a short brake run; after the brake-run, riders return to the station. Great Bear was the first inverted looping coaster in Pennsylvania.

• 
  Great Bear's full layout from the air
• 
  Great Bear's pre-drop helix (360-degree turn)
• 
  Great Bear's first drop
• 
  Great Bear's first drop, loop, and Immelmann (second inversion)
• 
  Great Bear's loop (first inversion).
• 
  Great Bear's Immelmann
• 
  Great Bear's zero-g roll (third inversion)