Fabrication and testing of optical components

Optical fabrication and testing spans an enormous range of manufacturing procedures and optical test configurations.

The manufacture of a conventional spherical lens typically begins with the generation of the optic's rough shape by grinding a glass blank.[1] This can be done, for example, with ring tools. Next, the lens surface is polished to its final form. Typically this is done by lapping—rotating and rubbing the rough lens surface against a tool with the desired surface shape, with a mixture of abrasives and fluid in between. Typically a carved pitch tool is used to polish the surface of a lens. The mixture of abrasive is called slurry and it is typically made from cerium or zirconium oxide in water with lubricants added to facilitate pitch tool movement without sticking to the lens. The particle size in the slurry is adjusted to get the desired shape and finish.

During polishing, the lens may be tested to confirm that the desired shape is being produced, and to ensure that the final shape has the correct form to within the allowed precision. The deviation of an optical surface from the correct shape is typically expressed in fractions of a wavelength, for some convenient wavelength of light (perhaps the wavelength at which the lens is to be used, or a visible wavelength for which a source is available). Inexpensive lenses may have deviations of form as large as several wavelengths (λ, 2λ, etc.). More typical industrial lenses would have deviations no larger than a quarter wavelength (λ/4). Precision lenses for use in applications such as lasers, interferometers, and holography have surfaces with a tenth of a wavelength (λ/10) tolerance or better. In addition to surface profile, a lens must meet requirements for surface quality (scratches, pits, specks, etc.) and accuracy of dimensions.

Overview of techniques used in optical fabrication

I. Glass blank manufacturing

II. Diamond shaping techniques

III. Loose grit fabrication techniques:

IV. Single-point diamond turning processes and equipment

V. Glass moulding techniques

Optical testing techniques

See also

Notes and references

  1. ↑ Shorey, Aric B.; Golini, Don; Kordonski, William (October 2007). "Surface finishing of complex optics". Optics and Photonics News. Optical Society of America. 18 (10): 14–16.

External links

This article is issued from Wikipedia - version of the 9/6/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.