South African Class 16DA 4-6-2 1928

This article is about one of two different South African locomotive types to be designated "Class 16DA". For the other SAR Class 16DA locomotive, see South African Class 16DA 4-6-2 1930.
South African Class 16DA 4-6-2 1928

Baldwin-built no. 850 at Theunissen, 29 May 2005
Type and origin
♠ With 60 inch (1,524 mm) coupled wheels
With 63 inch (1,600 mm) coupled wheels
22x26 Cylinders - 23x26 Cylinders
Power type Steam
Designer South African Railways
(Col F.R. Collins DSO)
Builder Hohenzollern Locomotive Works
Baldwin Locomotive Works
Serial number Hohenzollern 4653-4658
Baldwin 60820-60827
Model Class 16DA
Build date 1928-1929
Total produced 14
Specifications
Configuration 4-6-2 (Pacific)
Driver 2nd coupled axle
Gauge 3 ft 6 in (1,067 mm) Cape gauge
Leading dia. 30 in (762 mm)
Coupled dia. ♠ 60 in (1,524 mm)
63 in (1,600 mm)
Trailing dia. 33 in (838 mm)
Tender wheels 34 in (864 mm)
Wheelbase 60 ft 3 316 in (18,369 mm)
  Engine 30 ft 8 in (9,347 mm)
  Leading 6 ft 10 in (2,083 mm)
  Coupled 11 ft (3,353 mm)
  Tender 20 ft 5 in (6,223 mm)
  Tender bogie 6 ft 2 in (1,880 mm)
Length:
  Over couplers 68 ft 4 316 in (20,833 mm)
Height ♠ 12 ft 10 in (3,912 mm)
12 ft 11 12 in (3,950 mm)
Frame type Bar
Axle load ♠ 18 LT 15 cwt (19,050 kg)
19 LT 2 cwt (19,410 kg)
  Leading 18 LT 10 cwt (18,800 kg)
  Coupled ♠ 18 LT 15 cwt (19,050 kg)
  1st coupled 19 LT 2 cwt (19,410 kg)
  2nd coupled 19 LT (19,300 kg)
  3rd coupled 19 LT 2 cwt (19,410 kg)
  Trailing 14 LT 17 cwt (15,090 kg)
  Tender bogie Bogie 1: 33 LT 18 cwt (34,440 kg)
Bogie 2: 35 LT 10 cwt (36,070 kg)
  Tender axle 17 LT 15 cwt (18,030 kg)
Adhesive weight ♠ 56 LT 5 cwt (57,150 kg)
57 LT 4 cwt (58,120 kg)
Loco weight ♠ 89 LT 12 cwt (91,040 kg)
90 LT 11 cwt (92,000 kg)
Tender weight 69 LT 8 cwt (70,510 kg)
Total weight ♠ 159 LT (161,600 kg)
159 LT 19 cwt (162,500 kg)
Tender type KT (2-axle bogies)
Fuel type Coal
Fuel capacity 14 LT (14.2 t)
Water cap 6,000 imp gal (27,300 l)
Firebox type Round-top
  Firegrate area 45 sq ft (4.2 m2)
Boiler:
  Pitch ♠ 8 ft 6 in (2,591 mm)
8 ft 7 12 in (2,629 mm)
  Diameter 5 ft 10 14 in (1,784 mm)
  Tube plates 17 ft 10 58 in (5,451 mm)
  Small tubes 181: 2 in (51 mm)
  Large tubes 30: 5 38 in (137 mm)
Boiler pressure ♠ 195 psi (1,344 kPa)
205 psi (1,413 kPa)
Safety valve Pop
Heating surface 2,639 sq ft (245.2 m2)
  Tubes 2,453 sq ft (227.9 m2)
  Arch tubes 22 sq ft (2.0 m2)
  Firebox 164 sq ft (15.2 m2)
Superheater:
  Heating area 593 sq ft (55.1 m2)
Cylinders Two
Cylinder size 22 in (559 mm) bore
23 in (584 mm) bore
26 in (660 mm) stroke
Valve gear Walschaerts
Valve type Piston
Couplers AAR knuckle
Performance figures
Tractive effort 30,670 lbf (136.4 kN) @ 75%
33,530 lbf (149.1 kN) @ 75%
30,710 lbf (136.6 kN) @ 75%
33,570 lbf (149.3 kN) @ 75%
Career
Operators South African Railways
Class Class 16DA
Number in class 14
Numbers 843-850 & 868-873
Delivered 1928-1929
First run 1928
Withdrawn 1973

The South African Railways Class 16DA 4-6-2 of 1928 was a steam locomotive.

In 1928, the South African Railways placed six Class 16DA steam locomotives with a 4-6-2 Pacific type wheel arrangement in passenger train service. Eight more entered service in 1929.[1][2]

Manufacturers

Further orders for locomotives similar to the Class 16D Pacific type locomotive were placed for the South African Railways (SAR) in 1928. The design of the earlier engines was modified by the Chief Mechanical Engineer (CME), Colonel F.R. Collins, along the same lines as his design of the Class 15CA Mountain type.[1][2][3]

Col F.R. Collins DSO

This consisted of a locomotive bar frame which was shorter to end at the front of the firebox, with a bridle casting to create a widened frame extension below the firebox and the cab to the rear dragbox, to gain more ashpan room under the firebox.[1][2]

These redesigned locomotives were designated Class 16DA and were built by two manufacturers in 1928 and 1929. The first six, numbered in the range from 868 to 873, were built in Germany by Hohenzollern Locomotive Works and entered service in 1928. Another eight locomotives, numbered in the range from 843 to 850, were built in the United States of America by Baldwin Locomotive Works and entered service in 1929.[1][2]

Characteristics

The Hohenzollern and Baldwin-built Class 16DA locomotives basically differed from the predecessor Class 16D only by virtue of its shortened frame and bridle casting, the Class 16D having had a frame extending all the way from the front buffer beam to the rear dragbox. They used the same Type KT tenders with a coal capacity of 14 long tons (14.2 tonnes) and a water capacity of 6,000 imperial gallons (27,300 litres). As delivered, they had 60 inches (1,524 millimetres) diameter coupled wheels and their cylinders were of 22 inches (559 millimetres) bore and 26 inches (660 millimetres) stroke. Their boiler operating pressure was set at 195 pounds per square inch (1,344 kilopascals).[2][3]

Modification

During the 1940s, six of these locomotives, three from each manufacturer group, were retyred with 63 inches (1,600 millimetres) diameter tyres on their coupled wheels. To not have their tractive effort reduced by the larger coupled wheels, their cylinders were reamed from a 22 to 23 inches (559 to 584 millimetres) bore and their operating boiler pressure was raised to 205 pounds per square inch (1,410 kilopascals). All the modified locomotives remained classified as Class 16DA.[4][5]

When the larger tyres were fitted, the old tyres were left in position and turned down on the wheel centres to serve as liners, and the new tyres were then shrunk on over the liners. The practice of increasing the diameter of coupled wheels, wheel spacing and other considerations permitting, was begun by A.G. Watson during his term in office as CME and was continued by his successors. The reduction of tractive effort caused by the larger wheels, was made up by increasing boiler pressures or by fitting larger cylinders or both, as required. This policy resulted in more mileage between heavy repairs, less cost-per-mile on repairs and locomotives capable of higher speeds.[2]

Service

The Class 16DA Pacifics were initially placed in passenger service between Johannesburg and Kimberley, where they regularly worked trains like the Union Express, which became the Blue Train after the Second World War, and the Union Limited.[6]

In 1939-1940, when new air-conditioned rolling stock was placed in service on the Union Limited and Union Express services between Cape Town and Johannesburg, all the Class 16DA and Class 16E locomotives were transferred to Bloemfontein in the Free State. From here, they continued to work passenger trains north and south, including the Orange Express, until the Class 15F replaced them and they were relegated to suburban and local passenger train work. They were withdrawn from service in 1973.[6][7]

Four of the Baldwin-built locomotives were sold into industrial service. No. 844 went to Hlobane Colliery in Natal and later to Umgala Colliery. Numbers 845, 847 and 848 went to Wankie Colliery in Rhodesia, where they became numbers 5 to 7 in reverse order. After they were finally withdrawn in 1982, one of these three was plinthed alongside the main North road at Hwange. Another of the Baldwin-built locomotives, no. 850, is plinthed at Theunissen in the Free State.[3]

Works numbers

The table lists the Class 16DA engine numbers, builders, years built, works numbers and variations in coupled wheel sizes.[4][5]

Illustration

References

  1. 1 2 3 4 Holland, D.F. (1972). Steam Locomotives of the South African Railways, Volume 2: 1910-1955 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 57–58. ISBN 978-0-7153-5427-8.
  2. 1 2 3 4 5 6 Espitalier, T.J.; Day, W.A.J. (1946). The Locomotive in South Africa - A Brief History of Railway Development. Chapter VII - South African Railways (Continued). South African Railways and Harbours Magazine, May 1946. pp. 375-376.
  3. 1 2 3 Durrant, A E (1989). Twilight of South African Steam (1st ed.). Newton Abbott, London: David & Charles. p. 94. ISBN 0715386387.
  4. 1 2 South African Railways & Harbours/Suid Afrikaanse Spoorweë en Hawens (15 Aug 1941). Locomotive Diagram Book/Lokomotiefdiagramboek, 3'6" Gauge/Spoorwydte. SAR/SAS Mechanical Department/Werktuigkundige Dept. Drawing Office/Tekenkantoor, Pretoria. pp. 23-24.
  5. 1 2 South African Railways & Harbours/Suid Afrikaanse Spoorweë en Hawens (15 Aug 1941). Locomotive Diagram Book/Lokomotiefdiagramboek, 2'0" & 3'6" Gauge/Spoorwydte, Steam Locomotives/Stoomlokomotiewe. SAR/SAS Mechanical Department/Werktuigkundige Dept. Drawing Office/Tekenkantoor, Pretoria. pp. 6a-7a, 23-24.
  6. 1 2 Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. pp. 10–11, 67. ISBN 0869772112.
  7. Information supplied by Les Pivnic, retired Assistant Curator, South African Railway Museum
Wikimedia Commons has media related to South African Class 16DA (4-6-2) Hohenzollern and South African Class 16DA (4-6-2) Baldwin.
This article is issued from Wikipedia - version of the 5/24/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.